5.3.2. mvr vlan

Syntax

mvr vlan

Parameter

<VLAN-ID The exist static vlan id

Default

Default mvr vlan id is 1

Mode

Global Configuration

Usage

Use the mvr vlan command to modify mvr vlan id when the mvr status is enabled. Change mvr vlan id will delete the old mvr vlan and new mvr vlan group. If there have configure source or receiver port, there will check the source must only in the mvr vlan , and receiver port must not in the mvr vlan member. You can verify settings by the show mvr command.

Example

The following example specifies that configure mvr vlan 2.

Switch(config)# vlan 2
Switch(config)# mvr
The operation will delete groups of VLAN ID is MVR VLAN include static groups. Continue? [yes/no]:y
Switch(config)# mvr vlan 2
The operation will delete the old and new MVR VLAN groups include static MVR groups.Continue? [yes/no]:y
Switch# show mvr
MVR Running : Enabled
**MVR Multicast VLAN : 2**
MVR Group Range : None
MVR Max Multicast Groups : 128
MVR Current Multicast Groups : 0
MVR Global query response time : 1 sec
MVR Mode : compatible