2.8.2. show fiber-transceiver

Syntax

show fiber-transceiver interfaces IF_NMLPORTS

Parameter

interfaces IF_NMLPORTS

Display the o diagnostic information of the fibertransceiver for an interface ID or a list of interface IDs.

Default

Mode

Privileged EXEC

Usage

To show the diagnostic information of the fiber transceiver use the command show fiber-transceiver in the Privilegeg EXEC mode.

Example

The following example shows the diagnostic information for the interface gi1 and gi2, wherer the int fiber media ports with the transceiver inserted.

Switch# show fiber-transceiver interfaces gi1-2
Port | Temperature | Voltage | Current | Output power | Input
power |
| [C] | [Volt] | [mA] | [mWatt] | [mWatt] |
------------------------------------------------------------------------
gi1 | N/S | N/S | N/S | N/S | N/S | Insert |
gi2 | N/S | N/S | N/S | N/S | N/S | Insert |

Temp - Internally measured transceiver temperature Voltage - Internally measured supply voltage Current - Measured TX bias current Output Power - Measured TX output power in milliWatts Input Power - Measured RX received power in milliWatts OE-Present - SFP Presetn or Not Present LOS - Loss of signal N/A - Not Available, N/S - Not Supported, W - Warning, E – Error